Xeno Laboratories Test Blends Multi Ester Injectable Line
Out of stock
Injection · 200 mg/ml · 10 ml
Xeno Laboratories DHB is dihydroboldenone, also written as 1-testosterone, supplied at 200 mg/ml in a multi-dose vial. It is a DHT-derived androgen that does not aromatise, so no estradiol-linked water retention is expected from the molecule itself.
GMP-manufactured and HPLC-verified, with a Certificate of Analysis per batch, shipped internationally and to the United States with dispatch within two business days.
Xeno Laboratories DHB is dihydroboldenone, better known as 1-testosterone, at 200 mg/ml in a multi-dose vial for intramuscular injection. The structure is 17beta-hydroxy-5alpha-androst-1-en-3-one, a dihydrotestosterone derivative with one extra double bond, and that small change makes it considerably more androgenic than the compounds usually placed around it. It does not aromatise, so no estradiol is formed from it, which is why it is normally discussed next to a base ester such as Xeno Laboratories Testosterone.
Because the ring is already 5-alpha reduced, aromatase has nothing to work with and no estrogen is produced from the compound, which is the source of its dry reputation. The cypionate ester is the reason injections are infrequent: vendor profiles report a clearance of roughly six days, though no independent confirmation of that figure was found. Animal work quoted in reference material shows the compound matching testosterone propionate milligram for milligram on prostate and levator ani growth, but also raising liver mass, and injection site pain is reported by a substantial share of users.
Dihydroboldenone was never a registered medicine, so no approved schedule exists and every figure is a community protocol. Published references start at the lowest end of the range and stop in the low hundreds of milligrams per week, usually split over two or three injections, with a testosterone base alongside. Recovery planning is unavoidable because injected androgens suppress natural production, and the usual SERM discussion applies. Nothing on this page is a treatment protocol or a dosing guide.
For laboratory research only. Not for human or veterinary use. Information provided is for educational purposes only and does not constitute medical advice. Consult a healthcare professional before use.
| Trade Name | DHB |
| Generic Name | Dihydroboldenone (1-testosterone) |
| Manufacturer | Xeno Laboratories |
| Dosage | 200 mg/ml |
| Package | Multi-dose vial |
| Drug Class | Injectable anabolic androgenic steroid |
| Administration | Intramuscular injection |
| Storage | Room temperature, away from light and heat |
| Prescription Status | Controlled anabolic steroid, not a registered medicine |
| Verification | Third-party HPLC per batch, COA on file |
| Shipping | International and U.S. domestic options |
For laboratory research only. Consult a healthcare professional before use. Amounts shown are research references, not recommended human doses.
Before you ask
Yes. DHB is short for dihydroboldenone, and the same molecule is sold under the name 1-testosterone or 1-Test. Its structure is 17beta-hydroxy-5alpha-androst-1-en-3-one, which is a dihydrotestosterone skeleton with an additional double bond in the first ring. That single modification produces a markedly more androgenic compound than testosterone, and unlike boldenone it cannot be converted to estradiol.
No. The ring is already 5-alpha reduced, so aromatase has no substrate to act on and no estradiol is formed from this molecule. Water retention and breast tissue change are therefore not attributed to DHB itself. In any real block, though, the total hormonal picture is set by the whole combination, and an aromatising base ester in the same protocol produces the estrogen that dihydroboldenone does not.
Injection site pain is reported by a substantial share of users in vendor and community material, and this card states that as an observation rather than explaining it with a mechanism that no source provides. Higher concentration preparations are commonly described as more irritating. No published study measured pain scores for a 200 mg/ml preparation, so the practical point for a research setting is simply that this vial is known to be a painful one.
The androgenic load is the main theme: acne, hair shedding in predisposed users, and a fall in HDL with a rise in LDL in routine lipid panels. Injected androgens also suppress natural testosterone production, so recovery has to be planned. Animal work quoted in reference material records an increase in liver mass with this compound, a finding that has not been translated into a human liver signal and should not be read as one.
There is no registered human dose. Community material starts at the lowest end of the range and caps in the low hundreds of milligrams per week, split across two or three injections because of the ester, with a testosterone base supplying the aromatisation. Duration is usually described in weeks rather than months. These figures are community protocols quoted for completeness, not a recommendation, and the compound is not approved for human use.
This vial is listed as research material with international checkout and a U.S. domestic option. Orders are handled within one to two business days and every batch ships with an HPLC report and a Certificate of Analysis. Stock, variant and the current price are shown in the product block above; at the time of checking, the listing carried an out of stock marker while packs are restocked, so confirm the stock line before ordering.
Be the first to share your experience with Xeno Laboratories DHB 200 mg/ml Dihydroboldenone Cypionate
Log in to write a reviewComplete the cycle
Out of stock
Out of stock
Out of stock